* Not all tests are listed in the chart; for reference only.
Universal Type-C charging portRapid charge adaptor for charging at any timeSupplied with a 3.3 ft.(1 m) Type-C rapid charging cable and charging
adaptor, with a universal Type-C charging port for convenient
charging at any time.
Wide range of accessoriesIdeal for most operational requirements24 different types of S2 steel bits in 9 common categories, hardened to a maximum of 60HRC* for toughness and durability.The 2.36in(60mm) magnetic extension rod covers a wide range of applications.Eight different sizes of woodworking bits and metal twist drills meet the requirements for drilling a wide range of materials.Wood drill bitsMetal drill bits
Water-repellent storage pouch*Simple and compact designThe portable storage pouch is made of water-repellent fabric. The main unit, accessory case, adaptor and charger can all be stored in the bag, so you can easily and conveniently carry them all with you.
* The maximum torque error is ±5Nm due to the measurement device used. Torque test method: With the battery fully charged, the function selection button is pushed to enter screwing mode. A torque tester is then used to test the locked-rotor torque at level 30.* No-load speed tolerance is approximately 10%. Speed test method: The fully charged device is run for 2 minutes at no load and the no-load speed is then tested with a speed tester.* Screwing test method: With the device fully charged, the gearbox is adjusted to low speed (screwing mode). In manual "M" mode, the tail torque is adjusted to 10 and an M4 x 0.98in.(25mm) self-tapping screw is screwed into the pine board until the battery runs out.*Steel plate drilling test method: With the device fully charged, the gearbox is adjusted to the high-speed setting (drilling mode). In M mode, the tail torque is adjusted to 30 and a hole is drilled into a 6mm-thick steel plate with a 0.24in.(6mm) twist drill.*Wooden board drilling test method: With the device fully charged, the gearbox is adjusted to the high-speed setting (drilling mode). In M mode, the tail torque is adjusted to 30 and a 1.57in.(40mm)-deep hole is drilled into a white pine board with a 0.28in(7mm) wood bit.*The whole unit compliance test report was issued by Waltek Services Test Group Ltd. in Foshan; Test Report No.: WTF21F3015226G.*The whole unit ROHS test report was issued by EMTEK (Dongguan) Technology Co., Ltd.; Test Report No.: ED201110010C.*The EMC test report was issued by EMTEK (Shenzhen) Co., Ltd.; Test Report No.: ES201110017E.*The environmental reliability test report was issued by Intertek Shenzhen Ltd.; Test Report No.: SZHH01513728.*The battery test report was issued by Precise Testing & Certification (Guangdong) Co., Ltd.; Test Report No.: PTC20110204401S-GB01.*The screwdriver bit test report was issued by the National Light Industry Tool Hardware Quality Supervision & Testing Station, Shanghai. Test Report No.: G20201629F. Hardness varies by ±2HRC.* Two extension rod designs are available and will be shipped randomly.* The water-repellent fabric test was conducted by Centre Testing International Co., Ltd. and is waterproof up to class 4–5; Test Report No.: A2210085110101C.